99F38035 110V CellarSafe Safety Monitor with Carbon Dioxide, Battery - USA 2 Pin Plug by Crowcon
From fermentation through to distribution, Carbon Dioxide is one of the most common hazards to health in breweries, cellars and drinks outlets. It is also the fourth most abundant gas in the atmosphere. Long term exposure to only 0.5% volume represents a toxic health hazard. Concentrations greater than 15% volume can lead to death.
CellarSafe has been designed specifically to warn personnel of these hazards.
CellarSafe, the cost effective CO2 and Oxygen monitor you can trust.
Simple to use
- Clear back-lit display for gas readings
- Bright LEDs and loud, distinctive alarms
- Single button for routine operation and testing
- Plug-in repeater units complete with cable
- Calibration unit with automatic sequencing
- No specialist cabling required
Secure and robust
- IP65 protection against dust and water ingress
- Tough polycarbonate case
- Wide operating temperature range
- Battery backup for mains failure (optional)
- Dual-band infrared sensor for carbon dioxide
Protect yourself
- Continuous monitoring for carbon dioxide in cellars and other confined spaces
- Optional oxygen sensor to detect asphyxiation hazards due to nitrogen cylinder leaks
- Automatically turn on ventilation fans
- Factory set alarm levels
Save money
- Only turn on ventilation fans when they are needed
- Long-term maintenance-free operation
- Minimal sensor calibration requirements
- Long-life sensors
CellarSafe specification | |
Dimensions | 210 x 150 x 75 mm |
Weight | 1.3 kg |
Operating voltage | 230 V, 50/60 Hz ac, 16 VA, double insulated 115 V option available |
Operating temperature | +3°C to +50°C (37°F to 122°F) |
Warm up time | 40 seconds |
IP rating | IP 65 |
Display | Backlit LCD, 13.5 mm high digits |
Instrument status indicators | 2 gas level concentration alarm LEDs, red 1 fault alarm LED, yellow 1 power LED, green 1 sounder (>82 dB @ 10 cm) |
Cable length | 2 m |
Fixing centres | 4 at 192 mm x 72.5 mm |
Humidity | 0-99 % RH non-condensing |
Relay outputs | SPCO 10 A (240 V ac/30 V dc) |
EMC approvals | EN50270 FCC part 15 ICES-003 |
Repeater unit specification | |
Dimensions | 143 x 56 x 41 mm |
Weight | 120 g |
IP rating | IP 54 |
Instrument status indicators | 2 gas level concentration alarm LEDs, red 1 fault alarm LED, yellow 1 power LED, green 1 sounder (>82 dB @ 10 cm) |
Cable length | 9 m |